Mounting Of The Volume Flow Limiter; Electrical Connection Of The Instantaneous Water Heater; Opening Of The Instantaneous Water Heater; Terminals - oventrop W-HTE Notice D'utilisation

Instantaneous water heater for Regudis W-HTE
Mounting
4.3 Mounting of the volume fl ow
limiter
NOTICE
Damage to the instantaneous water
heater due to the permissible inlet
pressure being exceeded.
The instantaneous water heater is
approved for a maximum fl ow rate of up to
approx. 15 l/min. This corresponds to an
inlet pressure of the station of approx.
3.3 bar. If this value is exceeded in your
system constellation, damage can be
caused to the instantaneous water heater.
f
Mount the volume fl ow sensor (OV
item no. 1349981).
f
Remove the fl ow sensor (see position 3 in
Illust. 2 on page 18).
f
Mount the volume fl ow limiter as
described in the enclosed installation
instructions.
Illust. 4: Volume fl ow limiter
1 Volume fl ow limiter
20
1
4.4 Electrical connection of the
instantaneous water heater
Observe the instructions in the chapter
"Electrical connection", in particular the
paragraph "Connection to fi xed cable" in
the enclosed "Installation instructions for
qualifi ed tradespeople".
4.4.1 Opening of the instantaneous water
heater
Illust. 5: Opening of the instantaneous water
heater
1 Fixing of the bonnet
2

Terminals

4.4.2 Terminals
PE L1
Illust. 6: Terminals
1
2
L2 L3
134456180-V01.03.2021