Fixing Of The Instantaneous Water Heater; Piping - oventrop W-HTE Notice D'utilisation

Instantaneous water heater for Regudis W-HTE
Mounting
4.1 Fixing of the instantaneous water
heater
1
Illust. 3: Pre-fabricated bore holes
1 Pre-fabricated bore holes
NOTICE
Damage to rear installations
After mounting, the screws protrude up to
10 mm from the rear wall of the cabinet.
Pointed screws can cause damage to rear
installations.
f
Ensure that there is suffi cient space
behind the bore holes.
1.
Screw the enclosed screws into the
prefabricated bore holes.
The screws must protrude 5 mm.
2.
Hang the instantaneous water heater in
the suspension openings at the back and
carefully press it down until it locks into
place.
134456180-V01.03.2021
4.2

Piping

Please observe the separate operating
instructions of the components.
1.
Screw the reducing nipples for the
connections of the instantaneous water
heater (position (6) in Illust. 1 on page
17) with black EPDM sealing rings onto
the connections of the instantaneous
water heater.
2.
Screw the self-sealing sides of the double
nipples (positions (3) and (4) in Illust. 1 on
page 17) into the corresponding
connections of the ball valve connection
set.
3.
Screw the elbows (position 5 in Illust. 1 on
page 17) into the connections of the
heating circuit distributor/collector.
4.
Screw the appropriate pipe from the
connection and piping set between the
hot water outlet of the ball valve
connection set and the inlet of the
instantaneous water heater.
5.
Screw the appropriate pipe from the
connection and piping set between the
heating supply and the corresponding
elbow at the heating circuit distributor/
collector.
6.
Screw the appropriate pipe from the
connection and piping set between the
heating return and the corresponding
elbow at the heating circuit distributor/
collector.
EN
19