Instantaneous water heater for Regudis W-HTE
General information
1.
General information
The original operating instructions were
drafted in German.
The operating instructions in other languages
have been translated from German.
1.1
Validity of the operating
instructions
These operating instructions are valid for the
mounting of the OV instantaneous water
heater item no. 1344560 in the Oventrop
cabinets (OV item no 1344599 and 1344699).
1.2
Contact
Address
OVENTROP GmbH & Co. KG
Paul-Oventrop-Straße 1
59939 Olsberg
GERMANY
www.oventrop.com
Technical service
Phone: +49 (0) 29 62 82-234
1.3
Symbols used
Highlights important information and
further explanations.
f
Action required
•
List
1.
Fixed order. Steps 1 to X.
2.
Result of action
Z
14
2. Safety-related information
Observe the safety-related information in the
operating instructions of your dwelling station
and in the enclosed documents.
2.1
Correct use
Operating safety is only guaranteed if the
product is used correctly.
The instantaneous water heater is intended as
an extension module to the Regudis W-HTE
dwelling station.
It is suitable for wall mounting and in
combination with the enclosed connection
and piping set for mounting in suitable
Oventrop cabinets.
The instantaneous water heater serves as an
electronic reheater for potable water.
Any other use of the product will be
considered incorrect use.
Claims of any kind against the manufacturer
and/or its authorised representatives due to
damage caused by incorrect use will not be
accepted.
Observance of the operating instructions is
part of compliance with correct use.
2.2
Warnings
Each warning contains the following elements:
Warnsymbol
SIGNALWORT
Type and source of danger
Possible consequences if the danger occurs
or the warning is ignored.
f
Ways to avoid the danger.
The signal words identify the severity of the
danger arising from a situation.
134456180-V01.03.2021