Risk Of Injury In Case Of Improper Work; Damage To Property Due To An Unsuitable Installation Location; Availability Of The Operating Instructions; Technical Description - oventrop W-HTE Notice D'utilisation

Instantaneous water heater for Regudis W-HTE

Technical description

2.3.6 Risk of injury in case of improper
work
Stored residual energies, angular components
points and edges at the outside and inside of
the product may cause injuries.
f
Before starting work, make sure that there
is enough space.
f
Handle open and hard-edged components
with care.
f
Make sure that the work place is tidy and
clean to avoid accidents.
2.3.7 Damage to property due to an
unsuitable installation location
f
Do not install the product in locations
prone to frost.
2.3.8 Availability of the operating
instructions
Any person working on the product has to
read and apply these operating instructions
and all other valid documents.
The operating instructions must be available
at the installation location of the product.
f
Hand these operating instructions and all
other relevant documents over to the user.
16
3. Technical description
3.1

Functional description

The integrated cabinet mounting is only
intended in connection with the Oventrop
cabinets OV item no. 1344599 and
1344699.
If more than 8 heating circuits are
required, you must install the
instantaneous water heater outside the
cabinet.
With integrated cabinet mounting, a
differential pressure up to 150 mbar and
a volume flow up to 600 l/h is possible in
the heating circuit! For higher values, you
need a flow temperature control module
with its own pump (item no. 1344550). In
these cases, too, you must install the
instantaneous water heater outside the
cabinet due to the limited space available.
The instantaneous water heater is not
suitable for circulation operation!
The instantaneous water heater serves as an
electronic reheater for potable water.
The Regudis W-HTE home station preheats
the potable water. The heat output transferred
to the potable water depends on the heating
water quantity and the heating water
temperature supplied to the heat exchanger.
If this heat output is not sufficient to heat the
potable water to the desired temperature, the
temperature is increased by the instantaneous
water heater up to the set value.
The electronics of the instantaneous water
heater regulate the heating capacity
depending on the selected outlet temperature,
the respective inlet temperature and the flow
rate.
You can enter the desired outlet temperature
by pressing a key and read it on the digital
display.
134456180-V01.03.2021