Stiga HT 500 Li 48 Traduction De La Notice Originale page 28

PROBLEM
7. The cutting means
comes into contact with
a line or electric cable
8. The cutting means
comes into contact
with a foreign body.
9. Excessive noise and/or
vibration is experienced
whilst working
10. The machine gives off
smoke whilst working
11. Battery power
reserve is low
12. The battery charger
is not recharging
the battery
13. The LED indicator
(Fig. 6.F) remains
ON in steady mode
14. The LED indicator
(Fig. 6.F) remains ON
in flashing mode
If problems persist after implementing the solution, contact your Dealer.
PROBABLE CAUSE
-
-
Loose or damaged parts
Hedge trimmer is damaged.
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
Self-check failed
Battery communication error
Rotor blocked
Current overload
DO NOT TOUCH THE BLADE AS IT
MAY BE LIVE AND BE EXTREMELY
DANGEROUS! Grasp the machine using
the insulated rear hand grip only and
position it at a safe distance from yourself.
Disconnect the current that powers the
severed line or mains cable and remove
the battery before freeing the blade teeth.
Turn off the machine
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Turn off the machine
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Do not use the hedge trimmer. Immediately
turn off the machine
Contact an Authorised Service Centre.
Optimise operations (para. 8.2.1)
Use a second battery or an
extended battery (para. 16.1)
Purchase a new battery
Check it is correctly inserted (para. 8.2.3)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Optimize machine usage.
EN - 14
SOLUTION
remove the battery and:
remove the battery and:
remove the battery and
remove the battery
remove the battery
remove the battery