Stop; After Use; Routine Maintenance; General Information - Stiga HT 500 Li 48 Traduction De La Notice Originale

7.4.3 Lubricating the blades
whilst working
If the cutting means overheats whilst
working, it is necessary to lubricate the
internal surfaces of the blades (para. 8.4).
This operation can only be done
with the machine off and the battery
removed from its housing (para. 8.2.2).

7.5 STOP

To stop the machine:
• Release the blade control lever (Fig.
9.B) or the safety switch
• disengage the safety button
(light off) (Fig. 9.A).
When you have stopped the
machine, it will take a few seconds
for the cutting means to stop.
Always stop the machine:
– when moving between work areas.
Do not keep your finger on the safety
button when moving the machine to avoid
accidentally enabling the machine.
7.6

AFTER USE

7.6.1 After use with the battery
• Remove the battery from its housing
and recharge it (para. 8.2.2).
• When the cutting means has halted,
fit the blade guard (Fig. 1.E).
• Allow the engine to cool before
storing in an enclosed space.
• Clean (par. 8.3).
• Check there are no loose or damaged
components. If necessary, replace
the damaged components and tighten
any screws and loose bolts or contact
the authorised service centre.
Fig. 9.C);
(
7.6.2 After use with battery
simulator (if available)
1. Move the battery backpack
selector to "OFF" (Fig. 5.B);
2. remove the battery simulator
from the machine (Fig. 13.J);
3. remove the battery backpack;
4. disconnect the connection cable
from the battery simulator (Fig.13.I)
and from the backpack (fig. 5.A)
5. remove the battery from the backpack
(Fig. 14) and charge it (par. 8.2.2);
6. allow the engine to cool before storing
the machine in an enclosed space;
7. Clean (para. 8.3);
8. Make sure there are no loose or
damaged components. If necessary,
replace the damaged components and
tighten any screws and loose bolts or
contact the authorised service centre.
IMPORTANT Always remove the battery
(para. 8.2.2) and fit the blade guard whenever
the machine is unused or left unattended.

8. ROUTINE MAINTENANCE

8.1 GENERAL INFORMATION

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or hazards.
Before performing any
maintenance operations:
• stop the machine;
• Remove the battery from its housing
and recharge it (para. 8.2.2);
• when the cutting means is stationary,
apply the blade protection device, (except
when working directly on the blade);
• allow the engine to cool before
storing in an enclosed space;
• use suitable clothing, protective
gloves and goggles;
• read the relevant instructions.
EN - 9