Unpacking; Assembly; Fitting Of The Battery Backpack (If Available); Controls - Stiga HT 500 Li 48 Traduction De La Notice Originale

G. Battery charger (attachment on
request, par. 16.2): device used to
recharge the battery; its specifications
and regulations for use are described in
a specific manual. Two battery charger
models are available: G1 (fast battery
charge); G2 (standard battery charge);.
H. Battery backpack (attachment
on request, par. 16.3): device in
which the batteries are placed.
I. Connection cable: cable used to connect
the machine to the battery backpack.
J. Battery simulator (attachment on
request, par. 16.4): device that, if
inserted in the machine housing, allows
the use of the battery backpack.

4. UNPACKING

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or hazards.
Unpacking should be done on a flat
and stable surface, with enough space
for machine handling and its packaging,
always making use of suitable equipment.
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove the machine from the box.
4. Dispose of the box and packaging in
compliance with local regulations.

5. ASSEMBLY

5.1 FITTING OF THE BATTERY
BACKPACK (IF AVAILABLE)
The battery backpack is delivered
already assembled (Fig. 1.H) and can
be released from the strap support
(Fig. 3) and carried by hand.
To release the battery backpack, press
on the two upper buttons (Fig. 3.A).
The battery compartments are located
on both sides of the backpack (Fig. 4)
The following can be found on the
right side of the backpack:
• cable socket (Fig. 5.A)
• battery selector (Fig. 5.B)
• one USB port for charging other devices
(e.g. mobile phones) (Fig. 5.C).
To avoid any loose cables, there are
grooves on both sides and at the rear, in
which the power cable can be inserted.

6. CONTROLS

6.1 SAFETY BUTTON (ACTIVATION
/ DEACTIVATION)
Press this button to activate
and deactivate the machine's
electrical circuit (Fig. 6.A).
One LED lit: the machine's electrical
circuit is activated (Fig. 6.B).
The machine is ready for use.
Both LEDs lit: the machine is working.
LEDs off: The electrical circuit
is completely deactivated.
IMPORTANT Do not keep
your finger on the button when
moving the machine to avoid
accidentally enabling the machine.
The "Warning" icon (Fig. 6.F) comes
ON in the event of machine fault (refer
to the troubleshooting table, par. 15).
6.2 BLADE CONTROL LEVER
(CUTTING MEANS)
Used to start and regulate the blade speed.
It is only possible to activate the cutting
means (Fig. 1.B) when both the blade
control lever (Fig. 6.C) and the safety switch
(Fig. 6.D) are pressed simultaneously.
The cutting means stops automatically when
the lever or safety switch are released.

6.3 REAR HANDGRIP RELEASE LEVER

The release lever (Fig. 6.E) is used to adjust
the rear hand grip (Fig. 1.D) to 3 different
positions in relation to the cutting means
to make trimming your hedges easier.
The handgrip must only be
adjusted when the safety button
is deactivated (light off).
EN - 6