Configurations And Set-Up - Telecom Behnke a Serie Manuel

Manual Door intercom devices a / b series 20 / 30 / 40 / 50 / 20-0028A/-0028B
GB GB

Configurations and Set-up

configurations and
4.
set-up
The set-up can be performed directly at the door
intercom device via the internal configurations
keypad or remotely via a telephone with DTMF
dialling. On door intercom devices that come
with number keypads you may also use these
for configuration purposes. To enter set-up
mode, you need to enter a 4-digit security code.
The different settings are changed via configura-
tion step codes with an individual code for each
function to be set.
Enter set-up mode
Locally from your door intercom
▸
Press the * key (on the internal configurations
keypad or from a number keypad)
[beep]
▸
Enter the security code (default: 0 0 0 0)
[beep] [beep]
Remotely using a telephone with DTMF dialling
▸ Call your door intercom
▸
The device will answer the call with a [beep]
▸
Press the * key twice after the beep sound.
[beep]
▸
Enter the security code
(default: 0 0 0 0)
[beep] [beep]
Enter the configuration step code:
▸
Enter the configuration step code (cf. table
page)
[beep ] [beep]
▸
Enter the desired parameter and confirm with
the # key
[beep] [beep] [beep]
72
Exit set-up mode:
▸
Press the * key or after 30 seconds of inac-
tivity.
Set-up examples directly at the
intercom:
*0000 Enter Set-Up
10 Code to open the door #
21 Telephone number shall dial button 1 if any
button is pressed #
:
28 Telephone number shall dial button 8 if any
button is pressed #
* Exit Set-Up
www.behnke-online.com