Operating The Telephone; Terminating Set; Redialling; Keys For Pre-Select Phone Numbers And Speed Dialling - Telecom Behnke 40-9524 Mode D'emploi

operating the telephone

3.
To pick up a call, please tap the top side of the
receiver. The receiver will activate in your hand.
▸
Pick up the receiver and wait for the dial tone.
▸
Dial a phone number.
▸ Hang up after finishing your call.

3.1. Terminating set

The telephone is equipped with a magnetic ter-
minating set. To receive a dial tone or to start a
new call, you simply need to press the

3.2. Redialling

In case the dialled number is busy or to redial
the same number, please press
number will be automatically dialled. This
phone number will be saved until the next
call to a different phone number. Please note:
Phone numbers with more than 31 characters
cannot be saved.
www.behnke-online.com
Instructions for Telephone – TFT monitor - Videophone
3.3. Keys for pre-select phone numbers
and speed dialling
The telephone can save up to 11 phone numbers
with a maximum of 21 characters each. To save a
telephone number, please proceed as follows:
Pre-select phone numbers
▸
Pick up the receiver or press the
▸
Press keys
key. ▸ Enter the telephone number you wish to save.
▸
Press the
▸
Hang up or press the
Speed dialling
▸
Pick up the receiver or press the
and the ▸ Press keys
▸
Determine the position for speed dialling by
entering a value between 0-9.
▸
Enter the telephone number you wish to save.
▸
Press the
In case your telephone is connected to a
telephone system, you might need to include a
pause to receive a dial tone. To include a pause
in the telephone number saved, please press
the
Operating the telephone
and
key once.
key.
and
key once again and hang up.
key (e. g. 0 123456).
GB
key
key.
23