Configurations And Set-Up - Telecom Behnke 20-0001E Mode D'emploi

configurAtions And set-up

4.
Behnke door intercom devices are always set up
remotely via telephone (via DTMF signal = tone
dial). Call your Behnke door intercom using the
analogue extension number. To enter set-up
mode, you need to enter a 4-digit security code.
The different settings are changed via configura-
tion step codes with an individual code for each
function to be set.
Set-up using a telephone with DTMF dialling
▸ Call your door intercom
▸
Door intercom answers with three beeps (it is
possible to start the configuration mode for
the duration of the connection)
▸
Press the * key twice after the beep sound.
[Beep] (** must be entered within 2 s to start
the configuration)
▸
Enter the security code (default: 0 0 0 0)
[beep] [beep] (The security code must be
entered within 5 s after confirming the **
input)
Enter configuration steps (Enter a configuration
value incl. confirmation within 15 s after access-
ing the configuration step. In case of inactivity,
the configuration mode is automatically termi-
nated after 60 s and the set values are saved):
▸ Enter the configuration step code (cf. table
page)
[beep ] [beep]
▸
Enter the desired parameter and confirm with
the # key
[beep] [beep] [beep]
www.behnke-online.com
Anleitung Türstationen a / b Serie 20 / 40 / 50
Configurations and Set-up
Exit set-up mode:
Shortly press the * key or end the connection by
hanging up
Acknowledgement tones:
[beep] = Confirmation of finished configuration
[beep] [beep] = Configuration step entered
[beep] [beep] [beep] = Confirmation of an input
[beepbeep] [beepbeep] [beepbeep] [beepbeep] =
incorrect input
Set-up examples for the door intercom:
Call the door intercom using your analogue
extension number
Door intercom answers the call
**0000 (default safety code)
10 Code to open the door #
21 Telephone number that should be dialed
when pressing the 1 key #
:
24 Telephone number that should be dialed
when pressing the 4 key #
* Exit Set-Up
GB
35