Telecom Behnke a Serie Manuel page 74

Manual Door intercom devices a / b series 20 / 30 / 40 / 50 / 20-0028A/-0028B
GB GB
Configurations and Set-up
Code Parameter
Additional amplifier: Default setting: 0
07 0 = inactive
1 = soft
:
9 = loud
Please note: Here it makes sense to set values of 1 to 4.
Operations modes Relay 1: Default setting: 6
08 0 = inactive
1 = to be activated via the telephone
2 = to be activated via the number keypad
3 = to be activated via the telephone and the number keypad
4 = to be activated via the telephone & disconnecting after activation
5 = to be activated via the number keypad & disconnecting after activa-
tion
6 = to be activated via the telephone and the number keypad & discon-
necting after activation
7 = activated during outgoing calls
8 = activated during incoming calls
9 = activated during both incoming and outgoing calls
10 = activated at the beginning of an outgoing call
11 = activated at the beginning of an incoming call
12 = activated at the beginning of both outgoing and incoming calls
13 = activated during ringing
14 = activated in case of a fault (telephone line is down)
15 = to be activated via the emergency call centre
16 = activated during a direct call via button 1 (V1.20 or later)
17 = activated at the beginning of a direct dial from button 1 (V1.20 or
later)
18 = manually activated (V1.30 or later)
19 = automatic activation according to a schedule
(cf. configuration step 43) (V1.30 or later)
20 = activated after sending an emergency call (according to EN 81-70)
(V1.40 or later)
21 = activated when speaking in two-way communication (V1.42 or later)
22 = activated when listening in two-way communication (V1.42 or later)
74
Confirmation
#
#
:
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
www.behnke-online.com