Error Table - Telecom Behnke a Serie Manuel

error taBle

7.
During initialisation, the function of the most important electronics components is verified. If an
error occurs, a sequence of beeps allocated to a particular error will be audible, rather than the
normal high-pitch initialisation beep. You can find the allocations in the following table:
Beeps Error
3 EEprom error
4 Key matrix
error
5 Busy tone
decoder error
6 DTMF tone
decoder error
7 1kb-EEprom
from V1.30 or
later
8 Microphone
error
9 Microphone
error
10 Microphone
error
11 Microphone
error
www.behnke-online.com
Manual Door intercom devices a / b series 20 / 30 / 40 / 50 / 20-0028A/-0028B
Possible causes
▸
EEprom is not correctly installed in dedicated base
▸
EEprom faulty
▸
connected key, configuration button or number keypad is stuck
or faulty
▸
Connection cable for button or number keypad is damaged
▸ Interference
▸ Moisture on board or in connector
Busy tone decoder is faulty
DTMF tone decode component is faulty
Wrong EEprom, only 2kb EEproms are permitted for V1.30 or later
Compact device: the polarity of the connected microphone is
inverted
Universal device: the polarity of the microphone connected to the
integrated MLM is inverted
the polarity of the microphone connected to the MLM-A of an
universal device is inverted
the polarity of the microphone connected to the MLM-B of an
universal device is inverted
the polarity of the microphone connected to the MLM-C of an
universal device is inverted
GB
Error table
87