Configuration And Set-Up - Telecom Behnke 20 Serie Instructions

configuration and set-up

4.
You may either use the build-in configurations
keypad to directly configure the door intercom
station or a telephone with DTMF-dialling for
remote configuration. On door intercom devices
that come with number keypads you may also
use these for configuration purposes. To enter
set-up mode, you need to enter a 4-digit secu-
rity code. The different settings are changed
via configuration step codes with an individual
code for each function to be set.
Enter set-up mode
Locally from your Behnke door intercom:
▸
Press the * key (on the internal configurations
keypad or from a number keypad) [beep]
▸
Enter the security code (default: 0 0 0 0)
[beep] [beep]
Remotely by using a telephone with DTMF
dialling:
▸
Call your Behnke door intercom
▸
The device will answer the call with a [beep].
▸ Press the * key twice after the beep.
[beep]
▸
Enter the security code
(default: 0 0 0 0)
[beep] [beep]
Enter the configuration step code:
▸
Enter the configuration step code
(cf. table page) [beep ] [beep]
▸
Enter the desired parameter and confirm
with the # key [beep] [beep] [beep]
www.behnke-online.com
Manual Door intercom devices a / b Series 20 / 30 / 50
Configuration and Set-up
Exit set-up mode:
▸
Press the * key or after 30 seconds of
inactivity.
Example configurations entered directly at your
Behnke
door intercom:
* 0000 Enter Set-Up mode
10 Set a code to open the door #
21 Dial this number when button 1 is pressed #
:
28 Dial this number when button 8 is pressed #
* Exit Set-Up mode
GB
52