Self-Levelling Function; Sleep Function - geo-FENNEL FL 260VA Mode D'emploi

EN
SLOPE MODE
Slopes can be set manually up to 5° (± 9 %).
Press button (5) to enter the SLOPE function. The SLOPE LED (6) is illuminated. Press button (5) once
more to switch to the MAN function. The MAN LED is illuminated.
Choose the relevant axis (X, Y, Z) by pressing button (20) of the remote control.
SLOPE
Horizontal operation
One axis (X or Y) can be set manually, the other axis is automatically self-levelled.
Vertical operation
The direction of the X axis can be set manually, the Y axis is self-levelled.
In both horizontal and vertical operation the TILT and / or V-W-S function can be activated.
MAN
Horizontal operation
In this mode both (X and / or Y) axes can be set manually.
Vertical operation
Both (X and Z) axes can be set manually. In horizontal and vertical operation TILT and V-W-S cannot be
activated.
Press button (5) to quit the SOPE / MAN mode.
After leaving the slope function the TILT function is not active. If required press button (11).

SELF-LEVELLING FUNCTION

If the laser is disturbed, rotation stops and the laser beam and TILT LED (12) will flash.
Press button (10) to restart lelf-levelling.
The TILT function will automatically re-activate and the TILT LED (12) will be illuminated.

SLEEP FUNCTION

Press button (21) to activate the sleep function.
The POWER LED (9) flashes twice every three seconds for confirmation.
After 30 minutes in sleep mode the laser automatically switches off.
Press button (21) once more to quit the sleep function.
19