Control Panel; Power Led - geo-FENNEL FL 260VA Mode D'emploi

CONTROL PANEL

1. Scanning function button
2. Scan / point clockwise orientation button
3. Scan / point rotate anti-clockwise orientation button
4. MAN LED
5. MAN / SLOPE selection button
6. SLOPE LED
7 . Rotating speed button
8. ON / OFF button

9. POWER LED

10. Self-levelling button
11. TILT function button
12. TILT LED
13. Z direction LED
14. Y direction LED
15. X direction LED
16. Remote control shield button
17 . Remote control shield LED
18. Vibration-Wind-Security button
19. Vibration-Wind-Security LED
20. Slope X / Y / Z selection button
21. Remote control sleep button
22. Slope up adjustment button
23. Slope down adjustment button
ON/OFF BUTTON
Press the ON/OFF button (8) to switch the laser on. The POWER LED (9) is illuminated. Press the ON/
OFF button once more to switch the unit off.
If the POWER LED (9) is flashing during use the battery power is low.
ROTATING SPEED
After POWER ON the laser automatically rotates with the maximum speed of 800 rpm.
Press button (7) to reduce the speed to 300 rpm.
Press button (7) once more to stop the rotation.
Laser point function
Enter the „laser point function" by pressing button (7) until the rotation has stopped. Press button (2) to
orientate the laser point in a clockwise direction and button (3) for anti-clockwise.
5
4
2
17
1
19
18
16
3
1
20
10
7
6
7
8
9
10
11
12
13
14
3
2
22
21
23
EN
C
17