Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
FUNCTIONS
• Multi-functional laser for indoor and outdor applications
• Visible laser beam
• High accuracy
• Li-Ion battery technology
• Intelligent charger
• Stepless slope setting (manual) up to ± 5° (± 9 %) in X and Y axis
• Combine manual and automatic slope setting in two axes
• Two rotating speeds
• Variable scanning functions – both the scan range and scan direction can be adjusted
• Permanent 90° plumb beam
• TILT alarm function
• Operation with rechargeable or alkaline batteries
• Dust / water protection IP 66
• Horizontal slope setting function:
- Manual slope setting of X and Y axis
- Manual slope setting of one axis (X or Y), 2nd axis self-levelled
• Direction setting of vertical axis (with remote control only):
- Direction setting of X and Z axis
- Manual setting of X and Z axis, Y axis selflevelled
• Vibration-Wind-Security function (combined with TILT function) - rotation will not stop during light
ground / wind vibrations
• Remote control shield: Remote control can be switched off to avoid interference with other instru-
ments working on the same site
• Integrated floor mount with datum point
FLG 260VA-Green
• Same functions as FL 260VA, but with green laser diode
• Ideally suited for indoor applications
• Improved visibility of laser beam. Especially useful in bright surroundings and over longer distances.
B
BATTERY AND CHARGER
The instrument comes with with 3.6V Li-Ion rechargeable battery. The battery charger plug is con-
nected to the socket of the rechargeable battery pack (after removing the rubber plug). The battery
pack can be charged on or off the laser.
The charging LED of the charger indicates:
Permanent RED light = battery pack is being charged.
Permanent GREEN light = battery is fully charged.
The charging time is approx. 7 hours.
Before using the laser for the first time we recommend to fully charge the battery pack.
If the POWER LED (9) on the instrument control panel is flashing the battery pack needs to be charged.
The battery charger can be used to run the laser and charge the battery pack at the same time.
As an alternative, the laser can be powered by using the battery case for alkaline batteries
fitted with 3 x 1.5V C alkaline batteries.
16
Publicité
Table des Matières
