Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION WITH THE REMOTE CONTROL
SLOPE MODE (10)
SLOPE SETTING (11)
Slopes can be set up to ± 5° in X and Y direction.
Press button (10) to enter into this mode. To change between
X and Y axis press button (10) again. The LEDs (5) and (6)
show the axis chosen. To tilt the axis chosen press buttons
(11). To quit the slope mode press button (10) again.
SCAN FUNCTION (12)
Press button (12) to change from the rotation to the scan mode:
Press button 1 x = long scan line
Press button 2 x = short scan line
Press button 3 x = dot mode
SCAN DIRECTION (13)
Change the direction of the scan mode with button (13).
LED (14) - REMOTE CONTROL
This LED flashes if any button is used and a beep sounds.
ON / OFF REMOTE CONTROL FUNCTION (15)
With this button the remote control can be powered off - but not the instrument.
Press the ON/OFF button of the remote; the instrument will be in standby function. The ON/OFF LED
of the laser flashes. The values set will remain.
ROTATING SPEED - REMOTE BUTTON (16)
The instrument standardly rotates with max. speed (= 800 rpm). Press button (16) to change to
300 rpm.
If the batteries of the remote are empty each key pressure will cause a permanent sound.
Slope adjustment axis
direction selection button
Area scanning function
Rotation speed set button
10
12
16
EN
Slop
11
13
Area scan
or anti-clo
Power
14
Remote
15
27
Publicité
Table des Matières
