Entering A New Locomotive Address Into The Stack - Lenz Digital plus LH01 Mode D'emploi

16
8.2 Entering a new locomotive address into the
stack
Action Display
Press the right side of the rotary knob until
the LED to the right shines.
Release the knob to display the locomotive
address used last. The factory setting is
address 3.
Turn the knob until 'NEU' is displayed.
'NEU' is not displayed?
Click right. The digit that can be changed with
the rotary knob is marked with a dot.
Click left to change the 'single' digit that you
would like to change.
The 'ten' digit was selected.
The 'hundred' digit was selected.
The 'thousand' digit was selected.
The 'single' digit was selected again.
Explanation
This means that all twelve slots of the
stack are occupied
addresses. If the stack is full, you will
have to delete another locomotive address
from the stack (p. 18).
Information LH01
by locomotive