Lenz Digital plus LH01 Mode D'emploi page 87

This setting is stored in the command station LZ100/LZV100. When
calling up a locomotive address, the LH01 queries the setting from the
LZ100/LZV100. This setting can be made individually for each function
and locomotive address.
Action Display
Select the desired locomotive address for
which you would like to change a function.
Press the left side of the rotary knob until the
LED to the left shines.
The locomotive function selected last is
displayed. A dash on the right indicates that
the function is enabled.
Turn the rotary knob to display the function
that you would like to set to permanent or
temporary operation.
Click left. 'F.OPT' is displayed.
Release and ...
... click until the desired setting of the
locomotive function is displayed.
Press the centre of the rotary knob to set and
store the setting in the command station.
The dot on the right indicates the setting
'temporary operation'.
Explanation
23