Lenz Digital plus LH01 Mode D'emploi page 105

13.1.1 Reading a locomotive address
Place the locomotive whose address you would like to read on the
programming track.
Proceed as described under 'Setting and reading a locomotive
address on the programming track'.
Action
Either
Display
Select 'Read address'.
Press the centre of the rotary knob to start
the reading process.
The reading process takes some time. The
display shows 'BUSY'.
Once the reading process is completed, the
identified locomotive address is displayed.
press 'Esc' to return to read/write address
and ...
... press 'Esc' to return to 'Locomotive
control'
Explanation
41