Assigning Locomotive Functions To Function Keys - Lenz Digital plus LH01 Mode D'emploi

9.3 Assigning locomotive functions to function
keys
Ex-factory, or after re-entering a locomotive address into the stack,
function keys A, B, and C are assigned to functions F0, F1 and F2.
You can also assign other functions to the keys. Functions F0 to F28
are available.
The assignments of function keys are stored separately in
the stack for each locomotive address.
You can select different assignments for locomotive
addresses '1234' and '0003'.
Action
... the rotary knob to disable the function
again.
Press 'Esc' to leave the menu and return to
'Locomotive control'.
Display
Select the desired locomotive address.
Press the left side of the rotary knob until the
LED to the left shines.
The locomotive function selected last is
displayed (here: F0). A dash on the right
indicates that the function is enabled.
Turn the rotary knob to display the function
that you would like to assign to function key
A, B or C.
Explanation
21