Spark Arresting Screen In Muffler; Spark Plug - Stihl MS 362 C-Q Notice D'emploi

Fine tuning for operation at high
altitude
If idling behavior is erratic or
acceleration is poor
N Warm up the engine.
N Turn the low speed screw (L) 1/8 of
a turn (45°) counterclockwise.
It is usually necessary to change the
setting of the idle speed screw (LA) after
every correction to the low speed
screw (L).
A slight correction of the setting may be
necessary if the engine does not run
satisfactorily:
N
Turn high speed screw (H)
clockwise (leaner) – no further than
stop.
If the setting is too lean there is a
risk of engine damage due to
insufficient lubrication and
overheating.
MS 362 C-Q
All manuals and user guides at all-guides.com
Spark Arresting Screen in
Muffler
In some countries the muffler is
equipped with a spark arresting screen.
N If the engine is down on power,
check the spark arresting screen in
the muffler.
N Wait for the muffler to cool down.
1
2
N Take out the screw (1).
N Pull out the spark arresting
screen (2).
N
Clean the spark arresting screen. If
the screen is damaged or heavily
carbonized, fit a new one.
N Refit the spark arresting screen.
N Insert the screw and tighten it down.

Spark Plug

N If the engine is down on power,
difficult to start or runs poorly at idle
speed, first check the spark plug.
N Fit a new spark plug after about 100
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the spark plug
N Move the Master Control lever to
stop position (0)
N Push the hand guard forward – the
chain is locked.
2
1
N Open the twist locks (1) by turning
them 1/4 turn counterclockwise with
the combination wrench.
N Remove the shroud (2).
English
1
1
31