First-Time Use; First Wash Programme; Emergency Stop Switch - Schulthess SPIRIT ProLine WE 8080 Mode D'emploi

First-time use

Install the appliance in accordance with the setting-up
instructions.
First wash programme (empty)
Run the first programme with the appliance empty. This
is to remove any residual water from the testing proce-
dure.
1. Check that the transport securing devices on the front
and rear of the appliance have been removed. (see Set-
ting-up instructions).
2. Open the water taps.
3. Add half a measuring cup of all-purpose detergent to
chamber B.
Do not use detergent for delicates or woollens because
these generate too much foam.
4. Select the 60° Coloureds button
5. Press the «start button». The programme runs through.
6. At the end of the programme, the appliance is ready to
wash the first load.

Emergency stop switch

u The emergency stop switch is only to be used in the
event of danger and causes the extractor to stop imme-
diately. When actuated, the switch remains locked.
u Please do not use the emergency stop switch to stop
the extractor during normal operation.
u Once the fault has been rectified or the danger remo-
ved, the actuated emergency stop switch can be relea-
sed by turning the red mushroom-head button clockwi-
se.
u To restart the extractor, unlock the emergency switch
and press the Start/Stop button.
54
.