Cable cross-section
If the supply cables are too long while the cross-section of them is small, the voltage drops, which may
cause the motor difficulties. Therefore, a supply cable of sufficient cross-section is required for the saw
to work perfectly. The cables length show in the table applies to the distance between the
switchboard/fuse box and the trimming saw plug. It is of no relevance then whether a supply and an
extension cables are combined or it is a supply cable alone.
Cable length
to 15 m
15 – 40 m
Description of Unit
Required Cross-section
1.5 mm²
2.5 mm²
1. Handle and switch
2. Unlocking lever
3. Bench adjustment screw
4. Scale
5. Saw bench
6. Fixation holes
7. Bench widening device
8. Stop
9. Sawdust collection bag
10. Saw disc attachment
46
46