Steca Grid Vision 1800 Manuel page 55

EN
11.2.3 Address setting
The addressing is queried during initial commissioning and when an error occurs in the
device internal storage; see Section 7, p. 36 onwards.
11.2.4 Country setting
If settings are changed in the inverters, in some cases it may be necessary to set the
country again; see Section 7, p. 36 onwards.
734.144 | Z04 | 2012-11-22
Set country
This message means that the country has not been set
in any of the inverters and these are all running with
their default values. This is typically the case during
initial commissioning.
The displayed country selection list in English shows all
countries whose settings are supported by all invert-
ers.
 Select the correct country where your system is
installed.
Set country: No country available for all inverters
This message means that at least two inverters do not
support the same country and cannot feed into the
mains grid for legal reasons. Example:
• Inverter 1 supports Germany, Spain and Portugal.
• Inverter 2 supports France, Italy and Austria.
This message remains displayed until the incompatible
inverter is replaced.
 Contact your installer.
Colliding country codes: System shutdown
This message means that at least two inverters are
set to different countries and cannot feed the mains
grid for legal reasons. This is typically the case when a
system contains inverters that were previously used in
other countries.
The country selection displays the set countries in
English: Example:
• Inverter 1 is set to France.
• Inverter 2 is set to Germany.
If a third inverter with Spain set as the country is also
present then Spain will also be displayed.
53