Hazet-Werk Hazet 4794 Mode D'emploi page 21

• The timing belt must not be used for locking
the camshaft sprocket when slackening the
nuts.
• Do not forcibly twist a new belt or bend it
through a radius of less than 25 mm.
• Never lever or force the timing belt onto the
sprockets.
• Check free running of tensioner roller, guide
roller(s) and water pump.
• Check engine for leakages, if detected elimi­
nate them.
• Replace old timing belts with a new one and
ensure that it has the correct teeth profile.
• Ensure timing belt tension is correctly adjusted
(adhere to vehicle manufacturer's instructions).
• Observe torque specifications (adhere to vehi­
cle manufacturer's instructions).
• Pay regard to the timing belt's direction of rota­
tion which is indicated by an arrow.
• Do not reuse used timing belts. Always fit a
new one.
• In case of any appearance of wear as wear
points, cracks or damages as well as soiling
(e.g. by oil) , replace timing belt.
Maintenance work on engines must be carried out only by experienced mechanics.
For Your Safety
2
• If the timing belt shows damage, find out origin
• Do not use solvents or cleaning fluids like thin­
• Do not twist, bend or reverse the timing belt
• The engine must only be turned in the normal
• Only use parts, supports and accessories
• Repair work must be carried out exclusively by
• Only use the tools within the prescribed plac­
• For safety reasons any modification of HAZET
Always wear personal protective equipment.
and remedy deficiencies.
ner or benzine on belts, sprockets etc. In case
of doubt, remove the timing belt.
for inspection.
direction of rotation, unless otherwise noted by
the vehicle manufacturer.
which are recommended by the manufacturer.
authorized persons.
es, and governed under the current regulations
relating to the working environment.
tools is strictly forbidden. Any modification of
the tools will result in immediate exclusion from
warranty and liability.
21