Fitting The Desk Support; Wall Mounting; Adjusting The Display Contrast; Adjust Date And Time - switel T39 clip Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.6

Fitting the desk support

If you intend to use your telephone on a desk, then the desk support supplied must be fitted. To
do this, turn the telephone over. Now insert the two upper hooks into the openings provided and
push the desk support firmly home.
If you ever need to remove the support, press gently on the middle clips on the upper edge and
then pull the desk support off.
In the receiver rest there is a small hanging device, which is used when the telephone is wall
mounted. This hanging device is not required when the telephone is used on a desk, as it
impedes the lifting of the receiver. Using a small screwdriver, turn this hanging device until the
screw is completely flush and its upper end does not protrude at all.
3.7

Wall mounting

Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill two holes
vertically, 67 mm apart, and leave the screws protruding from the wall by 5mm. Now place the
telephone without the desk support over the screws and push it slightly downwards.
There is a small hanging device in the receiver rest to prevent the receiver from falling when it is
placed on the rest with the telephone mounted on the wall. Using a small screwdriver, turn this
hanging device until a small hook appears at the upper end.
If you are using the telephone fitted to the wall, you can hang the receiver on the telephone
without hanging up. You will find a small hook for this purpose at the upper end of the receiver
rest.
3.8

Adjusting the display contrast

With the receiver on the hook, the display contrast can be adjusted using the
3.9

Adjust date and time

1. Press the button
2. Enter the current hour by repeatedly pressing the
3. Confirm with the
4. Enter the current minutes by repeatedly pressing the
5. Confirm with the
6. Enter the current day by repeatedly pressing the
7. Confirm with the
8. Enter the current month by repeatedly pressing the
9. Confirm with the
shown in the display.
Note:
If the batteries are fully discharged, the time and date must be re−entered.
60
− Commissioning −
e
for 4 seconds.
H
button. The display jumps to the minutes display.
H
button. The cursor jumps to the day display.
H
button. The cursor jumps to the month display.
H
button. This completes the entries and the current data will now be
y
z
or
buttons.
y
z
or
buttons.
y
z
or
buttons.
y
z
or
buttons.
DE
buttons.

Publicité

Table des Matières
loading

Table des Matières