SATA jet 2000 LAB HVLP Mode D'emploi page 134

SATA LAB Automatic Gun Operating Instructions
EN
10.2. Replacing the air distribution ring
Replacing the air distribution ring must be preceded and followed by the
steps required for replacing the nozzle set (see chapter 10.1).
Dismantle the air distribution ring
The air distribution ring is fitted firmly in the nozzle head, which can be
damaged if excessive force is used. Injuries can be caused if the SATA
extraction tool slips during use.
→ Wear protective gloves.
→ Always use the SATA extraction tool pointing away from your body.
→ Pull the air distribution ring evenly out of the nozzle head.
■ Perform the steps to remove the nozzle set (see chapter 10.1).
■ Remove the air distribution ring [7-1] using the SATA extraction tool [7-2].
■ Check sealing surfaces for damage and soiling, clean or replace if necessary.
Fit new air distribution ring
■ Insert the air distribution ring [8-3] in the nozzle head [8-2]. The pin on the bot-
tom of the air distribution ring must be aligned accordingly [8-1].
■ Press the air distribution ring in evenly.
■ Perform the steps to fit the new nozzle set (see chapter 10.1).
10.3. Replacing the paint needle seal retainers
If the two paint needle seal retainers are damaged, material can leak
from the gun body inspection hole [1-16].
→ Replace the paint needle seal retainer immediately.
Dismantle the paint needle seal retainer
134
Attention!
Attention!