Replacing Inlet Guide - Miller Spoolmate 200 Manuel Du Propriétaire

5-5. Replacing Inlet Guide

7
2
Tools Needed:
M2
3
7
8
1
4
6
5
1 Cover
2 Pressure Roll Assembly
Cut off welding wire where it enters
pressure roll assembly area.
3 Nozzle
Pull wire out nozzle end.
4 Thumbscrew
Loosen thumbscrew and rotate
cover open.
5 Wire Spool
6 Spool Brake Thumbnut
Loosen thumbnut, retract wire onto
spool, secure, and remove spool.
7 Inlet Guide
8 Setscrew
Loosen setscrew to remove inlet
guide.
Install new guide and tighten
setscrew.
Reinstall spool and thread welding
wire (see Section 3-4).
Adjust spool brake pressure and
drive roll pressure if necessary (see
Section 3-6).
Close and secure cover.
Ref. 243 740-B
OM-243 762 Page 21