Adjusting Drive Roll And Spool Brake Pressure - Miller Spoolmate 200 Manuel Du Propriétaire

3-6. Adjusting Drive Roll And Spool Brake Pressure

5
Tools Needed:
1
2
Adjusting Pressure
WOOD
1 Cover
2 Thumbscrew
Loosen thumbscrew and rotate
cover open.
3 Spool
Cut welding wire off at contact tip.
Retract wire onto spool and secure.
4 Spool Brake Thumbnut
Grasp spool in one hand and turn
while adjusting spool brake thumb-
nut. When a slight force is needed
to turn spool, tension is set. Do not
overtighten.
Thread welding wire (see Section
3-4).
5 Drive Roll Tension Thumbnut
Turn On unit and check drive roll
pressure by feeding wire against a
wood board or concrete surface;
wire should feed steadily without
4 slipping.
Adjust drive roll tension thumbnut if
necessary. Do not overtighten.
Turn Off unit. Close cover.
3
Ref. 243 740-B / 243 736-B
OM-243 762 Page 15