Removing The Transport Lock - Stiebel Eltron ACCELERA 300 Manuel D'utilisation Et Installation

INSTALLATION
INSTALLATION
» Push two polystyrene
installation aids with the step-shaped
®
corner underneath the water heater. The water heater is
subsequently set and tilted onto this profile. Ensure that you
do not set the water heater down in the area of the joint edge
of the sheet steel jacket, but at least 150 mm (6") along.
» Tilt the water heater that has been set down on the
polystyrene ® installation aids.
» Remove the remaining floor semi-shell.
» In the tilted state of the water heater, wind out the second
and third leveling foot, but not by more than 30 mm (1.1").
» In both cases, tighten the locking nut against the bottom
cover.
» Position the water heater on the three leveling feet.
» Level the water heater vertically by adjusting the three
leveling feet.
» Remove any packaging that remains on the water heater.
» Install condensate drain elbow.

11.7 Removing the transport lock

There is a two-part transport lock to the heat pump unit of
the appliance. The transport lock must be removed before the
appliance is installed.
In its delivered condition, the appliance cover is held
in place by only 4 screws. The remaining screws for
the appliance cover can be found in a plastic bag supplied with
the appliance in the lower section of the appliance packaging.
» Undo the 4 screws in the appliance cover and remove the
cover to open the appliance.
» Remove the notice about secure transport which is fixed
between the appliance casing and cover.
18 | ACCELERA® 300 HEAT PUMP WATER HEATER
2
1 Transport lock part I
2 Transport Lock part II
3 Air intake
» Carefully remove transport lock part II by pulling it gently out
of transport lock part I.
» Remove transport lock part I.
» Ensure there is no packaging left in the appliance.
» Check the heat pump unit for transport damage.
» Position the cover back on the appliance and secure it with
the 8 supplied screws.
Never commission the appliance immediately after
removing the transport lock.
» Wait at least 1 hour before commissioning the appliance.
1
3
WWW.STIEBEL-ELTRON-USA.COM