Operating Instructions; Instructions Before Use - SKF TMBH 1 Mode D'emploi

3

OPERATING INSTRUCTIONS

3.1

Instructions before use

A. Make sure the line voltage is within the specified
range of 100 -240 V, 50 - 60 Hz. Properly
attach an approved cable plug (not delivered
with the unit due to local variations). Connect
the cable to the heater using the so-called
Euro-connector.
B. Connect the heating clamp to the control box.
Never connect or disconnect the heating clamp
during operation.
C. If the temperature mode is to be used, connect
the temperature probe to the heater. It is then
recommended to attach the probe to the hottest
part of the component which in general is the
part closest to the clamp. In case of heating a
bearing, always connect the probe to the inner
ring.
D. Turn on the main switch.
E. Insert the clamp through the bore of the
component to be heated. Continue according to
the instructions in chapter 3.2.
SKF TMBH 1 9