Operating Instructions; Instructions Before Use - SKF TMBH 1 Mode D'emploi

3. Operating instructions

3.1 Instructions before use

A. Make sure the line voltage is within the speciied
range of 100–240 V, 50–60 Hz.
Properly attach an approved cable plug (not
delivered with the unit due to local variations).
Connect the cable to the heater using the
so-called Euro-connector.
B. Connect the heating clamp to the control box.
Never connect or disconnect the heating clamp
during operation.
C. If the temperature mode is to be used, connect
the temperature probe to the heater.
It is then recommended to attach the probe
to the hottest part of the component which in
general is the part closest to the clamp.
In case of heating a bearing, always connect the
probe to the inner ring.
D. Turn on the main switch.
E. Insert the clamp through the bore of the
component to be heated. Continue according to
the instructions in chapter 3.2.
6 SKF TMBH 1