GB
At the end of the configuration and of the insertion of the operational parameters the unit remains predisposed for manual
operation. By pressing key (11)
with manual operation) and the green led is lit (6)
After selecting the parameter press key (18)
NOCCHI PUMPS
BAR 5.3
The unit is working on Automatic and the instant value of circuit pressure will appear on the display.
B) VARIATION PUMP INTERVENTION PRESSURE
Turn the general switch of the switchboard to position I (ON)
UNITS WITH PRESSURE TRANSDUCER
The following message will be displayed:
NOCCHI PUMPS
BAR 5.3
LINEA
The green led (2)
BEFORE THE BUZZER EMITS THE 8
M
Press key (11)
A
The following message will be displayed:
MANUALE FUNCTION
BAR 5.3
The buzzer automatically sounds off and the red led (5)
Press key (18)
ENTER
PRES. Bar PO:1
MAX05.5 MIN05.0
- Line n. 1 PRESS. BAR PO: 1
Indicates the number of pumps to which the pressure levels of the following line refer to
- Line n. 2 MAX0X.X
+
With keys (16)
or (17)
(normally 0). Confirm by pressing key (18)
units involved. With keys (16)
assigned to the pump which is initialized first. Press key (18)
confirming with key (18).
In the case of this example it is for 5.5 BARs
- Line n. 2 MIN0X.X
+
With keys (16)
(normally 0). Confirm by pressing key (18)
28
M
A
for a few seconds, the red led automatically switches off (5)
ENTER
MAN
and the red led (5)
TH
(EIGHTH) RING
for a few seconds
for 2 seconds and the following message will be displayed:
-
set the number in terms of tens of maximum pressure level of the first pump
ENTER
+
or (17)
ENTER
-
or (17)
set the number of the tens of minimum pressure value of the first pump
ENTER
AUT
(LED with automatic operation)
the following message will be displayed:
are both lit
MAN
remains turned on
. The cursor will change position depending on the number of
-
set the number of maximum pressure units (in BARs)
ENTER
and set the pressure decimal value always
. The position will change depending on the number of units
MAN
(LED