Renkforce 1000562 Notice D'emploi page 82

Recordings cannot be saved
• Insert a SD/SDHC memory card into the digital recorder (SD memory card max. 2GByte,
SDHC memory card max. 32GByte).
• Check the writing protection slider of the SD/SDHC memory card.
In some cheap memory cards, it may move so easily or be so large that it may be
operated by accident when inserting the memory card into the digital recorder slot.
• Is the memory card full? Insert a new, empty memory card into the digital recorder or
move the memory card contents onto the computer's hard disc.
• If required, activate automatic overwriting of the memory card, see chapter 11 d),
function „Overwrite". The oldest recordings are overwritten with the respective current
recording here and will be lost.
• Format the SD/SDHC memory card with the corresponding function of the digital
recorder, see chapter 11 c), function „format".
The digital recorder can only handle the file format FAT or FAT 32, but not, e.g.,
NTFS.
IR remote control does not work
• Remove the small transparent protective stripe from the battery compartment at initial
commissioning; pull it out completely.
• Replace the battery; observe correct polarity when inserting; see chapter 9 a).
• Align the small, transparent LED with the front of the IR remote control on the sensor
at the front of the digital recorder. The range usually is several meters.
• While a recording is running, many buttons have no function. Frist stop the recording
(push button „REC/STOP").
No playback of audio signals
• Set the volume at the digital recorder properly.
• Check the settings of your connected screen.
Bad image quality of the recording
• Switch from the 320 x 240 pixels resolution to a higher one (640 x 480 or 720 x 576 Pixel)
for the recording, see chapter 11 d), function „Rec Resolution".
82