Function „Motion Detect Setup - Renkforce 1000562 Notice D'emploi

Function „Motion Detect Setup"
In this function, the sensitivity for ,motion detection can be set in 3 steps; you can also
determine a specific (rectangular) image section for motion detection.
Selection of a lower sensitivity or specification of a certain image section is recom-
mended if there are, e.g., any trees and shrubbery in the monitored area the leaves of
which are moving in the wind.
If incorrect recordings happen often, not only reduce sensitivity but also activate
or reduce/move the image section for monitoring, align the camera differently
or install it elsewhere.
Proceed as follows:
• Use the buttons „2" and „8" to pick the function „Motion Detect Setup" and then
push „ ".
• Use the buttons „2" and „8" to choose between „Sensitivity" (sensitivity settings)
and „Area Setting" (setting an image section).
• Confirm the selection with „
1. „Sensitivity":
The sensitivity can be set in 3 steps („High", „Medium", „Low"). Select the desired step
as usual with the buttons „2" and „8" and then push „
2. „Area Setting":
The display shows a red frame. This is the current image section that is monitored for
movement.
The button „
increases it. The four arrows are used to move the frame.
Once you have set the size and position of the frame as desired, push the button
„MENU/ESC" on the digital recorder or the button „MENU" on the IR remote control
to leave the setting mode.
• Push the button „MENU/ESC" on the digital recorder or the button „MENU" or „ESC"
on the IR remote control repeatedly to return to the respective previous menu or leave
the OSD menu.
".
" can reduce the frame, the button „AUTO" on the IR remote control
" to save the settings.
73