Submenu „Recorder Setting; Function „Recording Type; Function „Recording Mode - Renkforce 1000562 Notice D'emploi

d) Submenu „Recorder Setting"
In the OSD menu, use the buttons „4" and „6" to select the submenu „Record Setting"
and push the button „
Function „Recording Type"
Here, you can choose if the digital recorder is to record photographs or videos.
Recording of pictures is only possible in the operating mode „One Key" (see
function „Recording Mode" below).
If you want to use motion detection (operating mode „Motion Detect") for
recording or automatic recording (operating mode „Schedule"), observe that
the recording of photographs is not possible either operating mode.
If you use recording of photographs in the function „Recording Type", the ope-
rating mode will automatically switch to „One Key" (see function „Recording
Mode".
Proceed as follows:
• Use the buttons „2" and „8" to pick the function „Recording Type" and then push
„ ".
• Use the buttons „2" and „8" to switch between „Photo" (recording of photographs)
and „Video" (Recording of videos).
• Confirm the selection with „
• Push the button „MENU/ESC" on the digital recorder or the button „MENU" or „ESC"
on the IR remote control repeatedly to return to the respective previous menu or leave
the OSD menu.
Function „Recording Mode"
In this function, you can choose three different operating modes for the video recor-
ding.
1. „One Key"
To start and end the recording, push the button (button „REC/STOP" on the digital recorder
or the IR remote control).
70
".
".