Commissioning; Inserting Batteries In The Ir Remote Control, Battery Replacement; Digital Recorder - Renkforce 1000562 Notice D'emploi

9. Commissioning

a) Inserting Batteries in the IR Remote Control, Battery
Replacement
The IR-remote control needs a battery type „CR2025".
At initial commissioning, the battery is already in the battery compartment of
the IR remote control. A plastic strip protects the battery from discharge.
Pull out the plastic strip to make the IR remote control operational.
A battery change is required if the range of the IR remote control drops or the digital
recorder no longer reacts to the IR remote control at all.
To perform the battery change, the locking clip at the battery compartment must be
unlatched, e.g. with a flat screwdriver, upon which the battery holder and battery can
be pulled out.
Replace the empty battery with a new one of type „CR2025". Always observe the correct
polarity (plus/+ and minus/-) when inserting the battery. The plus pole of the battery is
marked with the icon „+" and must point towards the bottom of the IR remote control.
Push the battery holder back into the IR remote control. Observe correct orientation.
Do not apply any force!
Dispose of the flat battery in an environmentally compatible manner; see chapter
„Disposal".
b) Digital Recorder
• Place the digital recorder on a level, firm, and sufficiently large area. Protect expensive
furniture surfaces from impressions and scratches and discolouration with suitable
pads.
• Connect the video output „AV out" (9) of the digital recorder to the video input of your
surveillance screen using the enclosed AV cable.
Depending on the screen used by you, the corresponding connection cable will be
required.
• The two AV inputs „AV1 in" and „AV2 in" (7/8) are available to connect surveillance
cameras.
56