Setting The Volume; Usb Connection - Renkforce 1000562 Notice D'emploi

e) Setting the Volume
The button „8" on the digital recorder or the IR remote control increases the volume,
the button „2" reduces it.
The display of the connected screen shows a bar chart with the currently set volume
level when the button is pushed. this display goes out again after a few seconds.
Also check the volume settings on the screen you use.
If your screen does not have installed speakers yet, the audio output of the
digital recorder may also be connected, e.g., to a line/aux input of the stereo
system or a radio.
If the cameras you are using have no audio output, the volume setting is irre-
levant.
f) USB Connection
The USB socket (3) and a suitable USB cable (not enclosed) can be used to read the
SD-/SDHC memory card as via a commercial card reader. The necessary drivers are
integrated into the operating system (at least Windows XP is recommended).
At connection, the corresponding message appears in the display of the connected
screen („USB Connect....").
While a recording is running, the USB connection has no function.
62