Communication Error Mobil-O-Graph Bluetooth Interface - IEM Mobil-O-Graph PWA Mode D'emploi

Troubleshooting
Error message
An error occurs during the
first measurement.
Communication error Mobil-O-Graph
Error indication
Code 1 Bluetooth interface of the Mobil-O-Graph
did not start up correctly.
Possible hardware fault.
Code 2 The Bluetooth interface of the Mobil-O-
Graph
(Communication problem between the
Mobil-O-Graph
Code 3 The status of the Bluetooth interface of the
Mobil-O-Graph
(Communication problem between the
Mobil-O-Graph
Code 4 The Bluetooth interface of the Mobil-O-
Graph
Bluetooth dongle.
108
Possible cause
The cuff size does not fit the arm
circumference of the patient.
®
Bluetooth interface
Possible cause
®
could not be configured correctly.
®
and Bluetooth module.)
®
could not be determined.
®
and Bluetooth module.)
®
is not yet connected to the
Check the circumference of the
arm using the tape measure
provided and compare it to the
information printed on the cuff.
Remedy
®
Send the device to your specialist supplier
or directly to IEM GmbH for checking.
Try it again.
If the error persists, send the device to your
specialist supplier or directly to IEM GmbH
for checking.
Try it again.
If the error persists, send the device to your
specialist supplier or directly to IEM GmbH
for checking.
Try connecting to the device
®
via Bluetooth again.
Measures