IEM Mobil-O-Graph PWA Mode D'emploi page 119

▪
Align the cuff so that no part of the cuff tube can be kinked. Align the cuff so that the lower edge of the cuff
is about 2 cm (0,8 Inch) above your elbow, see Fig. 2.
▪
Place the cuff around the upper arm in such a way that one finger can be inserted underneath the cuff.
▪
Make sure that the artery symbol on the cuff is positioned on the arm artery (brachial artery), see Fig. 2.
▪
When the cuff is put on correctly, the metal strap lies on the outside
of the upper arm (on the elbow side). Here, the fabric strap must
cover the skin underneath the metal strap.
▪
We recommend placing the cuff on the bare upper arm. However,
the cuff can also be worn over a thin shirt or a blouse.
▪
Put the holster on. By varying the length of the strap, you can use
it either as a waist strap or as a shoulder strap.
▪
Insert the Mobil-O-Graph
connection and the buttons are freely accessible for operation.
▪
Switch the Mobil-O-Graph
▪
Start a new blood pressure measurement by pressing the START
button.
®
into the holster so that the cuff
®
on using the ON/OFF button.
Appendix
Fig. 2: Positioning of the cuffs
EN
117