IEM Mobil-O-Graph PWA Mode D'emploi page 118

Appendix
ATTENTION
▪
Do not open the casing. Once the device has been opened, any warranty will no longer be valid.
▪
Liquid must not get into the device. If you want to have a shower or bath, switch off the device and take it
off. Make sure that you put it back on properly afterwards and switch it on! If you think that liquid has
entered the device, the device must not be used. Switch the device off and remove the batteries.
▪
Do not wear any other electrical medical devices on the arm you are using to measure your blood pressure
and do not use the device in the vicinity of an MRI scanner.
▪
The device must not be used on aeroplanes.
▪
®
The Mobil-O-Graph
electromagnetic fields as this may cause malfunction outside the limits. You should therefore ensure that
®
the Mobil-O-Graph
Taking off the cuff and blood pressure measuring device
If you need to remove the cuff and the device (e.g. to have a shower), proceed as follows:
▪
Switch the device off using the ON/OFF button.
▪
Remove the cuff from the arm.
▪
Take the device and the shoulder strap off.
Putting on the cuff and blood pressure measuring device
The correct positioning of the arm cuff is very important for an accurate measurement and should always be done
on the same arm.
To put the cuff and blood pressure measuring device on again, follow these instructions:
▪
The tube connection on the cuff must face upwards, see Fig. 1.
▪
The course of the cuff tube should ensure free movement of the upper arm and should be guided around
the neck to the other side of the body.
116
fulfils all requirements of the EMC standards, but it should not be exposed to strong
is at least 30 cm (12 inches) from any portable RF communication devices.