Start-Up; Checking How Easily The Pump Rotates; Filling With Water - aqua technix AQUA AQ 280 Installation

Start-up

6 Start-up
The pump can be damaged if it runs dry!

6.1

Checking how easily the pump rotates

After longer idle periods, the pump must be checked for how easily it
rotates while it is switched off.

6.2

Filling with water

System
Below the
water level
Above the
water level
With
suspended
skimmer
High cp.oncentrations of water treatment chemicals can damage the
filter system!

PLEASE NOTE: THE 6-WAY VALVE (10) MAY ONLY BE
OPERATED WHEN THE FILTER PUMP (40) IS SWITCHED OFF.
OTHERWISE THE 6-WAY VALVE (10) CAN BE DAMAGED!
50 EN VG 766.2050.052
Ensure that the pump is full of water.
Place screwdriver in the groove on the end of the motor shaft (on
the fan side) and turn it clockwise.
Filling with water

Open the shut-off valve at the suction and pressure
side (not included in the scope of delivery)

Do not install the filter system more than 3 m below
the pool water level

Use self-priming pump

See pump operating instructions

Fill the pump with water through the pre-filter and
screw the pump cover back on

Ensure that the seal in the lid is not damaged or
twisted

Do not install the filter system more than 2 m
above the water level

Do not connect the suction hose to the skimmer
until it is completely filled with water
Do not place water treatment products, particularly in tablet form,
into the strainer basket of the pump or filter system.
08/2015