Locking / Unlocking; Connecting A Power Pack (Accessory) - Metz mecablitz 64 AF-1 digital Mode D'emploi

Acoustic signals after the flash unit has been
turned on:
• A short (about two seconds) uninterrupted
beep signal after turning the flash on indi-
cates that the flash unit is ready.
Set Beep signals when adjusting automatic
mode settings:
• A short beep signal as an alarm in auto-
matic mode indicates that the aperture and
ISO settings exceed the permissible light
control range. The auto aperture of the
mecablitz is then automatically adjusted to
the next permissible value.
k
204

11.10 Locking / unlocking

The setting on the flash unit can be locked
GN
against unintended changes.
To lock or unlock, hold down the
for approximately 3 seconds.
3.6m
On the screen, all the sensor buttons are
M-
5,6
m
35
Zoom F
shown in white and can no longer be
m
EV
accessed.
Only the INFO sensor button can be pressed.
11.11 Connecting a power pack
(accessory)
A power pack (accessory) can be connected
to the flash unit using port
You need a connection cable (special acces-
sory) to connect the power pack.
The power pack extends the operating time
of the flash unit and provides faster flash
recycling times.
D
button
.