Metz mecablitz 64 AF-1 digital Mode D'emploi page 182

Masquer les pouces Voir aussi pour mecablitz 64 AF-1 digital:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 56
Strobe flash frequency (f)
Strobe mode allows you to select the flash
frequency (f), which indicates the number of
flashes per second. The number of flashes
can be set from 1 to 100. The maximum
manual partial light output is automatically
adjusted to this number.
If you desire short flashes, you can manually
reduce the partial light output to the lowest
value of 1/256.
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears.
TTL
Thereafter, the flash unit always switches
on with the mode of operation that was
k
0.6- 7.2 m
used last.
M-
• Press the sensor button of the displayed
5,6
m
35
Zoom
F
m
mode of operation on the touch display as
EV
many times as it takes for the display for
selecting the mode of operation to appear.
O
MODE
• Press the
touch display and select
GN
• Press the
STROBO
touch display.
REMOTE MASTER
p
q
182
sensor buttons on the
STROBO
.
STROBO
sensor button on the
• Set a suitable mode of operation on the
STROBO
camera, e.g.
M-
2,5m
35
m
Zoom
m
• Tap the shutter release to transfer data
between the flash unit and the camera.
5
5
N
f(Hz)
P
1/8
Set number of flashes (N)
• Press the sensor button for the number of
STROBO
flashes
M-
2,5m
m
35
Zoom
m
5
10
N
f(Hz)
• Press the
P
1/16
touch display and select the desired num-
ber of flashes.
O
N
The maximum possible number of flashes
3
(N) depends on the set partial light output
4
(P).
5
• Press the sensor button on the touch
p
q
display for the desired number of flashes
(in the example
The setting will take effect immediately.
M
.
N
on the touch display.
sensor buttons on the
4
.

Publicité

Table des Matières
loading

Table des Matières