Beep Function (Beep) - Metz mecablitz 64 AF-1 digital Mode D'emploi

• The first shot is taken without a correction
value. „FB I" will also appear on the
display.
• The second shot is taken with minus correc-
tion. „FB II" and the minus correction value
(EV) will also appear on the display.
• The third shot is taken with plus correction.
„FB III" and the plus correction value (EV)
will also appear on the display.
• After the third shot, the flash bracketing
series is automatically deleted. „FB" will
disappear from the display.
When the flash bracketing series is set,
the correction value is always shown as a
positive value!
Flash bracketing series in the TTL flash mode
A flash bracketing series in the TTL flash
mode is only possible if the camera supports
the setting of a manual flash exposure
correction on the flash unit (see camera
instruction manual)! Otherwise, the shots
are taken without a correction value!
Flash bracketing in automatic flash mode A
The type of camera is not important for a
flash bracketing series in automatic flash
mode A.

11.9 Beep function (BEEP)

The beep function allows the user to receive
an acoustic signal for certain functions of the
flash unit. This allows the photographer to
concentrate fully on the subject and taking
the picture, and not have to worry about any
optical status indicators!
The beep function acoustically signals when
the flash is ready or when an error occurs.
Setting procedure
D
• Press the
for the selection menu to appear.
OPTION
OPTION
• Press the
touch display.
O
OPTION
MOD. LIGHT • Press the
touch display and select
BEEP
• Press the
m/ft
touch display.
p
q
O
BEEP
• Press the
display.
OFF
„ " appears in the INFO menu after activati-
ON
on of the BEEP function.
button as often as it takes
sensor button on the
sensor buttons on the
BEEP
.
BEEP
sensor button on the
ON
sensor button on the touch
203
k