Metz mecablitz 64 AF-1 digital Mode D'emploi page 172

automatic unit switch-off is shown in the
INFO display. The flash ready indicator
the indicators on the LC display disappear.
The
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
using the main switch
k
to be used for an extended period!
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
In all operating modes, the brightness of the
screen is reduced by 50 per cent after
approx. 10 seconds to save energy.
The screen brightness is restored again
whenever a button or a symbol on the screen
is pressed.
172
D
button flashes red in stand-by
D
button, or by tapping on
if it is not going
Setting the automatic unit switch-off
and
• Switch on the flash unit with the
• Press the
• Press the
OPTION
O
OPTION
• Press the
ZOOM MODE
STANDBY
• Press the
MOD. LIGHT
p
q
• Tap the sensor button on the touch display
O
STANDBY
OFF
The
1 min
mode.
10 min
The start screen appears.
The flash unit always switches on after-
wards with the mode of operation that was
used last (e.g. manual flash mode M).
D
button as often as it takes
for the selection menu to appear.
OPTION
sensor button on the
touch display.
sensor buttons on the
STANDBY
touch display and select
STANDBY
sensor button on the
touch display.
for the desired time. The setting is adopted
immediately.
D
button flashes red in stand-by
button.
.