Special Functions; Motor Zoom Reflector („Zoom") - Metz mecablitz 64 AF-1 digital Mode D'emploi

and be adjusted to the correction factor
(depending on the camera model)!
TTL
Setting procedure
• Press the
0.6- 7.2 m
display as many times as it takes for the
partial light output selection to appear.
M-
5,6
m
35
Zoom F
m
EV
• Press the
O
EV
touch display and set a correction value.
-1 1/3 • Press the selected correction value on the
touch display, e.g.
-1
The setting will take effect immediately.
-2/3
Manual flash exposure correction is only
p
q
possible in TTL flash mode if the camera
supports this function (consult the camera's
TTL
operating instructions)!
k
If the camera does not support this function,
0.9- 10 m
the adjusted correction will have no effect.
M-
5,6
m
35
F For some camera models, the manual flash
Zoom
m
EV exposure corrections must be adjusted on
-1
the camera. If this is the case, no correction
value will appear on the flash unit display.
+
After the shot, remember to cancel the manual
flash exposure correction in the camera!
184
EV
sensor buttons on the touch
sensor buttons on the
-1
.
+
Strongly reflecting objects in the motif can
have a negative impact on the camera's
automatic exposure. The photograph will be
underexposed. Remove reflecting objects or
set a positive correction value.

9 Special functions

Depending on the camera model or camera
group, various special functions are
available.
For this purpose, data exchange must first
occur between the flash unit and camera to
access and set the special functions, for
example by tapping the shutter release.
The setting must occur immediately after
accessing the special functions since other-
wise the flash unit automatically switches
back to normal flash operation after a few
seconds!
9.1 Motor zoom reflector („Zoom")
The motor zoom reflector of the flash unit
can illuminate lens angles from 24 mm
(35 mm format).
Thanks to the use of the integrated wide-
angle diffuser
to 12 mm.
, the illumination widens