Beep Function (Beep); Locking / Unlocking - Metz mecablitz 64 AF-1 digital Mode D'emploi

11.11 Beep function (BEEP)

The beep function allows the user to receive
an acoustic signal for certain functions of the
flash unit. This allows the photographer to
concentrate fully on the subject and taking
the picture, and not have to worry about any
optical status indicators.
The beep function acoustically signals when
the flash is ready or when an error occurs.
Setting procedure
• Press the
for the selection menu to appear.
• Press the
OPTION
touch display.
O
OPTION
• Press the
MOD. LIGHT
touch display and select
BEEP
k
• Press the
m/ft
touch display.
p
q
O
BEEP
• Press the
OFF
display.
The setting is adopted immediately.
ON
„ " appears in the INFO menu after activati-
on of the BEEP function.
202
D
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
BEEP
.
BEEP
sensor button on the
On
sensor button on the touch
Acoustic signals after the flash unit has been
turned on:
• A short (about two seconds) uninterrupted
beep signal after turning the flash on indi-
cates that the flash unit is ready.
Set Beep signals when adjusting automatic
mode settings:
• A short beep signal as an alarm in automa-
tic mode indicates that the aperture and
ISO settings exceed the permissible light
control range. The auto aperture of the
mecablitz is then automatically adjusted to
the next permissible value.

11.12 Locking / unlocking

The setting on the flash unit can be locked
against unintended changes.
To lock or unlock, hold down the
button for approximately 3 seconds.
On the screen, all the sensor buttons are
shown in white and can no longer be acces-
sed.
Only the INFO sensor button can be pressed.
D