Switching On The Pv Load-Break Switch; Commissioning; Lcs Tool - SMA SUNNY TRIPOWER 60 Instructions D'installation

SMA Solar Technology AG
3.2.2 Switching on the PV Load-Break
Switch
Figure 3.2. PV load-break switch
Switch on the PV load-break switch on, either via inverter or
PV array junction box.

3.2.3 Commissioning

The inverter starts automatically if sufficient solar irradiation
is available. Commissioning takes a few minutes. During this
period, the inverter performs a self-test.
INFORMATION
The inverter is equipped with reverse polarity
protection. The inverter does not generate feed-in
power until any reverse polarity is corrected.

3.3 LCS tool

The STP 60 inverters and the SMA Inverter Manager must
be commissioned via the local commissioning and service
tool (LCS tool). Commissioning is required before the
STP 60 inverters are connected to the utility grid and start to
feed-in power.
The LCS tool is available in the download area at
www.SMA-Solar.com.
The hardware requirements for the LCS tool are:
TM
• PC with Windows
• 1 GB HDD
• 2 GB RAM
The LCS tool must be installed on a local PC drive. The PC
must be connected to the SMA Inverter Manager's LAN 1
port via Ethernet.
Installation Guide
7 and later
INFORMATION
The SMA Inverter Manager must have an IP address
assigned by a DHCP server on port LAN 1.
It is important that the PC running the LCS tool is
connected to the same IP subnet as the
SMA Inverter Manager.
Port LAN 2 is intended for STP 60 inverters only.
STP60-10-IA-xx-10
3 Initial Setup and Start
31